What is the reason for non condensable gas in the condenser of ultra-low temperature cooling water c
When the ultra-low temperature cooling water chiller is running, it is necessary to pay attention to the gas state generated by the condenser under a certain temperature and pressure. The existence of these gases affects the operation of the ultra-low temperature cooling water chiller. What is the reason?
1. The refrigeration system is not fully drained before charging refrigerant
Before the ultra-low temperature cooling water chiller is charged with the refrigerator, the compressor cylinder, condenser, evaporator and system pipeline in the refrigeration system have been filled with air. In order to eliminate these air before charging the refrigerant, it is necessary to vacuum the refrigeration system of the ultra-low temperature cooling water chiller. Sometimes, due to subjective and objective reasons, the vacuum in the refrigeration system is insufficient, If it fails to meet the requirements, a small amount of air is left inside the system.
2. Bring in when filling refrigerant
Before filling the refrigerant in the refrigeration system of the ultra-low temperature cooling water chiller, the pipes used for filling are filled with air. Due to human and other reasons, when filling the refrigerant, the air in the pipes is not exhausted, so they are directly connected to the refrigeration system, and these air enter the refrigeration system with the filled refrigerant.
3. Non condensable gas is mixed during maintenance of refrigeration system
When the refrigeration system of ultra-low temperature cooling water chiller works for a long time, it is inevitable to check, repair or clean and replace, so sometimes it is necessary to disassemble the machinery or pipeline, and the air often enters the refrigeration system in the process of disassembly and installation.
4. Chemical reaction from refrigerant
In the ammonia refrigeration system of ultra-low temperature cooling water chiller, refrigerant ammonia can be decomposed into ammonia and hydrogen at a certain temperature and pressure, and its decomposition degree has a positive relationship with temperature and pressure. The higher the temperature is, the greater the pressure is, the easier it is to decompose ammonia.
In the freon refrigeration system, freon may react with impurities mixed into the system to produce non condensable gas. For example, R12 reacts with water under certain conditions to produce carbon dioxide
5. The decomposition of lubricating oil will also produce non condensable gas
Among the lubricating oils used in the refrigeration system, some lubricating oils, such as mineral lubricating oil, can decompose under complex working conditions to produce a variety of hydrocarbon gases, which will be mixed into the refrigerant in the system.
These are the reasons for non condensable gas in the ultra-low temperature cooling water chiller. Users try to avoid these reasons in use and operate the ultra-low temperature cooling water system stably.
Related recommendations
-
Trouble shooting method for water cut off of cooling system driven by wheel motor
2083Long-term use of the wheel motor to drive the cooling system can encounter any kind of failure. For the wheel-side motor drive cooling system, if there is a water cut problem, it is very dangerous and must be dealt with in a timely and effective m...
View details -
What do the LNEYA chiller fault codes mean? What is the solution?
3074Q: What is the fault code of the chiller? Answer: E1 means extremely high indoor temperature alarm, E2 means extremely high temperature alarm, E3 means extremely low temperature alarm, E4 means indoor temperature controller failure, E5 means water...
View details -
Cooling and heating thermostat for running electronic component testing
2186If enterprises want the cooling and heating thermostats for electronic component testing to operate for a long time without any faults, they need to achieve the following points to maintain stable equipment performance. 1. Suitable working enviro...
View details -
Operation Precautions for ZLF/SR Series Reactor Temperature Control Equipment
2156The temperature control equipment of the reaction kettle adopts the PID control method, which greatly improves the temperature control accuracy of the whole machine. The microcomputer for cooling or heating will automatically switch to work accord...
View details
LNEYA Thermo Refrigeration Co.,Ltd












